smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.131+truenas] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Device Model: TOSHIBA MQ02ABD100H Serial Number: 96GGT0NHT LU WWN Device Id: 5 000039 741786c56 Firmware Version: HEF01D User Capacity: 1,000,204,886,016 bytes [1.00 TB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches TRIM Command: Available, deterministic Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 3.0, 6.0 Gb/s (current: 3.0 Gb/s) Local Time is: Sat Jan 20 15:14:48 2024 EST SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 198) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 128 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0 3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 2829 5 Reallocated_Sector_Ct 0x0033 100 100 050 Pre-fail Always - 0 9 Power_On_Hours 0x0032 068 068 000 Old_age Always - 12981 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 2643 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 37 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 25 193 Load_Cycle_Count 0x0032 089 089 000 Old_age Always - 117116 194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 23 (Min/Max 14/50) 199 UDMA_CRC_Error_Count 0x0032 200 253 000 Old_age Always - 0 240 Head_Flying_Hours 0x0032 079 079 000 Old_age Always - 8441 241 Total_LBAs_Written 0x0032 100 100 000 Old_age Always - 27941312852 242 Total_LBAs_Read 0x0032 100 100 000 Old_age Always - 22555925366 254 Free_Fall_Sensor 0x0032 100 100 000 Old_age Always - 0 SMART Error Log Version: 1 ATA Error Count: 9 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 9 occurred at disk power-on lifetime: 12868 hours (536 days + 4 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 50 50 01 01 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- aa aa aa aa aa aa aa ff 00:00:28.398 [RESERVED] aa aa aa aa aa aa aa ff 00:00:28.118 [RESERVED] 25 00 01 00 00 00 40 00 00:00:21.334 READ DMA EXT 25 00 40 00 00 00 40 00 00:00:21.333 READ DMA EXT 25 00 01 00 00 00 40 00 00:00:11.152 READ DMA EXT Error 8 occurred at disk power-on lifetime: 12844 hours (535 days + 4 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 50 50 01 01 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- aa aa aa aa aa aa aa ff 00:00:32.380 [RESERVED] aa aa aa aa aa aa aa ff 00:00:32.083 [RESERVED] 25 00 01 00 00 00 40 00 00:00:15.002 READ DMA EXT 25 00 40 00 00 00 40 00 00:00:15.001 READ DMA EXT 25 00 00 00 ff 6f 40 00 00:00:15.001 READ DMA EXT Error 7 occurred at disk power-on lifetime: 12745 hours (531 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 50 50 01 01 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- aa aa aa aa aa aa aa ff 00:00:25.141 [RESERVED] aa aa aa aa aa aa aa ff 00:00:24.841 [RESERVED] 25 00 01 00 00 00 40 00 00:00:18.024 READ DMA EXT 25 00 40 00 00 00 40 00 00:00:18.024 READ DMA EXT 25 00 01 00 00 00 40 00 00:00:11.440 READ DMA EXT Error 6 occurred at disk power-on lifetime: 12376 hours (515 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 50 50 01 01 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- aa aa aa aa aa aa aa ff 2d+12:34:17.744 [RESERVED] 47 00 01 10 00 00 a0 00 2d+12:34:17.734 READ LOG DMA EXT 60 08 00 00 00 00 40 00 2d+12:34:17.698 READ FPDMA QUEUED 47 00 01 12 00 00 a0 00 2d+12:34:17.696 READ LOG DMA EXT 47 00 01 00 00 00 a0 00 2d+12:34:17.696 READ LOG DMA EXT Error 5 occurred at disk power-on lifetime: 12376 hours (515 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 50 50 01 01 00 00 00 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- aa aa aa aa aa aa aa ff 2d+12:34:16.612 [RESERVED] aa aa aa aa aa aa aa ff 2d+12:34:16.331 [RESERVED] 25 00 01 00 00 00 40 00 2d+12:34:09.501 READ DMA EXT 25 00 40 00 00 00 40 00 2d+12:34:09.500 READ DMA EXT ec 00 00 00 00 00 00 00 2d+12:33:59.084 IDENTIFY DEVICE SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 12935 - # 2 Extended offline Completed without error 00% 12321 - # 3 Extended offline Completed without error 00% 3826 - # 4 Short offline Completed without error 00% 3823 - # 5 Short offline Completed without error 00% 3629 - # 6 Short offline Completed without error 00% 3385 - # 7 Short offline Completed without error 00% 3005 - # 8 Short offline Completed without error 00% 2614 - # 9 Short offline Completed without error 00% 2516 - #10 Short offline Completed without error 00% 1864 - #11 Short offline Completed without error 00% 1836 - #12 Short offline Completed without error 00% 1772 - #13 Short offline Completed without error 00% 1768 - #14 Short offline Completed without error 00% 1638 - #15 Short offline Completed without error 00% 1320 - #16 Short offline Completed without error 00% 1041 - #17 Short offline Completed without error 00% 830 - #18 Short offline Completed without error 00% 461 - #19 Short offline Completed without error 00% 260 - #20 Short offline Completed without error 00% 1 - #21 Short offline Completed without error 00% 1 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.